Thomas, Thank you for your insight. Apparently, the error was solved by putting any other value except 0 s for the starting time. The CMC ran without any error interruption. However, regarding the tracking task weight, will increasing the value be able to help increase the accuracy of the muscle act...

So, I've been trying to run CMC tool for my gait analysis. However, this error message appears at the same time of the CMC analysis if I set the analysis time from 0 to 1.03333 s (legible recorded motion). "Unable to find a feasible solution at time = 0.7." However, the analysis would've completed i...

To begin with, I am trying to run simulation up to CMC tool. My experiment involved motion capture of gait cycle. The marker placement follows modified Helen-Hayes configuration for both sides of the legs. 7 markers each side - 14 in total for both sides - 7 markers each side - the active markers pl...

Hi Aaron,

Thank you for the heads up! I'll make sure to check them!


Willem

I had a set-up consisting of 2 action cameras (GoPro). So far, the set-up and the application (self-built) from my biomechanics lab have only been attuned to take only one side of the body (right leg). The use of 4 action cameras to take both sides is still under-development, so i'd rather not use i...

So, I am trying to scale the model using the .trc data converted by the toolbox. Unfortunately, it just so happened that the toolbox wrote the "OrigDataStartFrame" as "OrigDataStarFrame" which doesn't allow the scaling process to continue. At the bottom right corner, a warning keeps mentioning it wh...