Hello Dear,
Would you please let me know if there way to resolve this issue of running the CMC and receiving this message below as the attached.
Thank you so much in advance for your help

Good day,
I have a gait model seated. see the attached. Legs not moving. scaled without markers. Is there way to simulate by running static optimization, RRA and CMC?
Please advise. Any help much appreciated . Thank you

good day,
Would you please tell me how to create .trc file and save it to be used it in OpenSim?
Thank you.

Good day, Would you please let me know if you can scale without marker. 1- When I tried to ran it and went to run IK the system crashed and disappeared? 2- Is there source of setting in scale factor at static weights where you can make changes gait subject model 2392? 3- Is the only place to make ch...

Good day,
Would you please let me know if there is an example of EMG based generating CMC. Thank you.

Hi Dear, I have been using the lower limb model to analyze human gait I encountered a problem when I used the CMC fails after running the simulation. Note: that the gait is sitting position 90 degrees the right leg the pelvis still remains on the same place, the segment of the knee will move a littl...

Good day,
I have subject at sitting on chair at 90 degrees. when I run the simulation for IK, ID, RRA every is fine however, when it comes to select tool exestuation failed run the CMC. Please help and see the attached. Thanks in advance.

Good day,
Would you please let me know how to process EMG into activation dynamics in muscle model before simulation run. Thank you so much for any input.

I have a question about using OpenSim. More specifically, I want to find the muscle forces (in the quadriceps) under isometric contraction. I measured the flexion angle (constant at 90 degrees) and ground reaction force as a function of time . Will appreciate any example that does this task or any g...

Good afternoon,
Would you please tell if there is new manual for OpenSim, and more details about how to install EMG into OpenSim. Thank you so much for your time.

A. Benwli