I found out what the problem was. It was a high tolerance on the residuals. By setting a lower value, the oscillations disappeared.

Thank you anyway,
Giuseppe

Good morning, and you're welcome for the response. I could certainly try reducing the number of points in my inflow.flow file again, although I've already attempted that. I also tried setting the Fourier value to 10. However, I can give it another try. As for the geometry: it differs from the base m...

wgyang wrote: ↑

Mon Apr 22, 2024 6:39 pm

Could you grant me the access to your files so that I can take a look?
Thanks!

I should have shared the folder with you. Giuseppe

Update: I've tried another project, with a different model/mesh and with its own inflow conditions as well as RCR conditions. This time, the results are better. I can't figure out what might have caused the error I mentioned earlier. My doubts lie in these areas: the choice of the Fourier number, po...

Good evening, I am encountering an issue with the results of my simulations. I successfully ran the Tutorial1 simulation without any problems with the results. To continue my study with simplicity, I used the inflow data from Tutorial1 with my own problem, and there too I had no issues; the pressure...

Hi Dave,

I've already installed gcc11 and open-mpi4.1.6, but I'm still have these issues. I used Homebrew for the installation. Could this be the problem?

I'll try to building svSolver from source on your Mac.

Thanks,

Giuseppe

Good morning everyone, I've tried to install SimVascular several times on my macbook air with M2 chip and macOS Sanoma, and each time it seems there's an issue. I've checked multiple times to ensure that the required programs, such as gcc, vtk, and open-mpi, are installed. Specifically, the program ...