Thanks Ursula for the note! Hope you got a great result

Hi Tobi,

I'm sorry for the late reply. I'm not monitoring this forum very often. The best way to double check the motion data is using the Preview Motion Data function in OpenSim. If the resultant files are imported well into opensim and look good, you should be all set.


Best

Sangjun

Dear all, I'm getting tons of inquires on problems occurred while using the toolbox, and 99% of the them are related to the csv file formatting. The toolbox works only for csv files that are exported properly from Vicon Nexus, so please read the manual and follow the instruction carefully. Note that...

Hi all, Lee-Son's Toolbox is currently introduced at the OpenSim Documentation as one of 'Tools for Preparing Motion Data.' You can find some information of Lee-Son's Toolbox and other similar tools at the link below. As Lee-Son's Toolbox is an independent SW, those who are not familiar with Enginee...

Hi Bruce, If you get the proper result when you use the first csv, then you are doing right. We guarantee that our toolbox works fine only with csv files that are directly generated by VICON NEXUS properly. If you edit the csv, the file format can change because of the editing program that you use (...

Hi Margaret, If the toolbox result in such error, it is likely that the format of the csv file is different. In Marika's case, there were additional empty lines between every two lines in her csv file. If you send me your csv via E-mail, I will check your file. (E-mail address: skylsj@snu.ac.kr) Bes...

Hi Ursula, I'm so sorry for late reply. I could not monitor this forum for a while for personal reasons. The manual says our toolbox can be used only for AMTI force plates. This is because we have only AMTI force plates in our lab, so we could not test its compatibility with other types of force pla...

Hi all, Recently, I found that our toolbox is detected as a virus in some strict vaccine environments. :( I think that since the toolbox *.exe directly creates and modifies the output files, the vaccine environment misunderstands the toolbox as a malignant code. :( If you have this kind of problems,...

Dear Marika,

I replied to you via e-mail, and updated our toolbox.
Please check that.

Thanks,
Sanjun Lee.

Hi Michalina, I'm Sangjun Lee, the developer of the Lee-Son's Toolbox. Although our toolbox was developed based on data from AMTI force plates, it seems to work fine with any kind of force plates so far. If you have any problem in using our toolbox, please contact us via our project page, https://si...