Dear Sanjun Lee, Thank you very much for both your replies. I did not reply to your email only because I hadn't yet had the time to work in detail with the updated version of the toolbox. But from the little time I spent checking it out it seems to be ok now. Again, thank you, I really appreciate yo...

Thanks for your reply Ayman.

I only realised that there was a section of the forum about the toolbox today or I wouldn't have posted this here. Hopefully someone knowledgeable about the toolbox sees my other thread over there.

I tried using the Lee-son toolbox (both versions I found) to convert a csv file. The file from the vicon system wasn't saved by me so I wouldn't know if the system was set up correctly or not. When I clicked Convert data and selected the file, the toolbox stopped responding. I tried this multiple ti...

I was trying to use the Lee-son toolbox to convert a csv file to trc and mot for use in opensim. However, when I click convert data, select the file and click open, the toolbox seems to be working for a couple of seconds, then it stops responding. I tried using both the versions of the toolbox that ...

I would also like to do something similar to what fadyalnajjar was doing. Was any solution found?

In finally installed a 32 bit version of matlab and tried using the gait extraction tool again. I'm getting the following: Toolbox will be added to the matlab path in: C:\GaitExtractToolbox171 Ready to proceed with installation? (y/n): y Step 1: Install c3dServer & C3DViewer (Motion Labs) Step 2: Se...

Thanks Tim. I will try that.

I downloaded the C3D Extraction Toolbox from here: https://simtk.org/project/xml/downloads.xml?group_id=341#package_id574 and tried to install it. I followed the initial instructions. When I clicked run in matlab this was the outcome: Instructions ------------ 1) Copy the ENTIRE toolbox directory to...