Search found 13 matches
- Fri Feb 27, 2015 7:35 am
- Forum: OpenSim
- Topic: RRA iteration
- Replies: 1
- Views: 172
Re: RRA iteration
I'm not sure if residuals can increase during iterations. But, you can check if the residuals are acting at the scaled pelvis in the RRA actuators.xml file (Applies if you have scaled your model). You can also try using the suggested mass changes shown in messages section after your initial RRA run....
- Sat Feb 07, 2015 2:18 pm
- Forum: OpenSim
- Topic: Inbuilt filter used in Inverse Dynamics
- Replies: 1
- Views: 221
Inbuilt filter used in Inverse Dynamics
Hello all,
What is the inbuilt filter used in Inverse Dynamics?
We usually set the filter frequency to negative value if the data doesn't need filtering and around 6Hz if it does.
Thanks in advance for the reply.
What is the inbuilt filter used in Inverse Dynamics?
We usually set the filter frequency to negative value if the data doesn't need filtering and around 6Hz if it does.
Thanks in advance for the reply.
- Fri Feb 06, 2015 8:31 am
- Forum: OpenSim
- Topic: Questions in RRA, CMC and Analyze Tool
- Replies: 9
- Views: 2641
Re: Questions in RRA, CMC and Analyze Tool
I have figured out few of the questions above and I post them for those of you who didn't know them yet. 1. It is always a good practice to make the force residuals fall at least in that "OK" range given in OpenSim tutorials. So, I have changed the Actuators to act at the scaled pelvis COM. Here is ...