SCONE shuts down when I try to run a scenario

SCONE is a software tool for predictive simulations of biomechanical movement. It uses OpenSim for modeling and simulation, and performs optimization using various control strategies, including feed-forward control, proprioceptic feedback control, and bal
POST REPLY
User avatar
Aoife Ryan
Posts: 10
Joined: Tue Sep 24, 2019 3:23 am

SCONE shuts down when I try to run a scenario

Post by Aoife Ryan » Sat Nov 16, 2019 8:58 am

Hi Thomas,

I am trying to load a cycling model into SCONE (using a nonsense gaitmeasure at the minute, as I'm just playing around with it until I have found a way to measure the cycling ability of the model), however, if I try to optimise the scenario, I can leave it for hours without anything being optimised and if I attempt to run the scenario SCONE immediately shuts down.
Notes came up in the messaging window about unsupported actuators, so I removed those but unfortunately it did not seem to fix the problem.
Have you any suggestions as to how I might deal with this?

Thanks,
Aoife
Top
User avatar
Thomas Geijtenbeek
Posts: 461
Joined: Wed Mar 12, 2014 8:08 am

Re: SCONE shuts down when I try to run a scenario

Post by Thomas Geijtenbeek » Mon Nov 18, 2019 2:08 am

Hi Aoife,

Thank you for taking the time to report this!

Could you send me the model you're using (and also the .scone file)? This way, I can figure out what's happening and fix the problem. You can send it to me either via e-mail, or via the SCONE Github Page.

Thanks,
Thomas
Top
POST REPLY