meshing error/ not responding difference

Provides a system for patient-specific cardiovascular modeling and simulation.
POST REPLY
User avatar
Atefeh Razavi
Posts: 33
Joined: Sun Mar 04, 2018 10:47 am

meshing error/ not responding difference

Post by Atefeh Razavi » Tue Feb 05, 2019 3:30 pm

Hello,

I create and smoothed a model (including aorta and coronary arteries) as suggested by Justin on the topic "Boundary Layer Meshing",
viewtopicPhpbb.php?f=188&t=9214&p=25430&start=0&view=
However the mesh either is failed or does not respond (attached) while it is being appended even with no boundary layer meshing. I was wondering to know what the differences are between these two errors, and if there is any suggestion to make the mesh to work.

I am using TetGen, applying local and regional refinements. The problem occurs when I add the regional refinement to the left coronary artery bifurcation.
I tried to attach the model, but it was too large.

I would appreciate any suggestion.

Thank you,
Ati
Attachments
error_mesh.PNG
error_mesh.PNG (25.09 KiB) Viewed 198 times
mesh_run.PNG
mesh_run.PNG (21.99 KiB) Viewed 198 times
Top
User avatar
David Parker
Posts: 1632
Joined: Tue Aug 23, 2005 2:43 pm

Re: meshing error/ not responding difference

Post by David Parker » Fri Feb 08, 2019 3:45 pm

Hi Ati,

Upload your model to https://github.com/SimVascular/SimVascular/issues/398 and I'll have a look. I will also need the parameters you used for your local and regional refinements.

Cheers,
Dave
Top
POST REPLY