Imported STL will not Mesh

[Melton Parham]

Hi SimVascular Community,

My name is Melton Parham, graduate student at the University of Colorado-Boulder and I wanted to ask for any assistance with an error I am experiencing in SimVascular. The error occurs when I am trying to import a STL model created from3D Slicer into SimVascular. When attempting to complete the meshing step, the software stops at 33% and does not complete the mesh, along with this error (see attached picture)

Is there any suggestions or advice I can do to overcome this challenge?

Here is a link to the project folder if needed:
https://o365coloradoedu-my.sharepoint.c ... 1&e=vrftRB

Additionally here a few details of my setup:
OS: Windows 64
Version: SimVascular 2023.03.27(MITK 2018.4.2 VTK)
Solver: 202208-19

Thank you,
Melton