Hello,
I create and smoothed a model (including aorta and coronary arteries) as suggested by Justin on the topic "Boundary Layer Meshing",
viewtopicPhpbb.php?f=188&t=9214&p=25430&start=0&view=
However the mesh either is failed or does not respond (attached) while it is being appended even with no boundary layer meshing. I was wondering to know what the differences are between these two errors, and if there is any suggestion to make the mesh to work.
I am using TetGen, applying local and regional refinements. The problem occurs when I add the regional refinement to the left coronary artery bifurcation.
I tried to attach the model, but it was too large.
I would appreciate any suggestion.
Thank you,
Ati
meshing error/ not responding difference
- Atefeh Razavi
- Posts: 33
- Joined: Sun Mar 04, 2018 10:47 am
meshing error/ not responding difference
- Attachments
-
- error_mesh.PNG (25.09 KiB) Viewed 199 times
-
- mesh_run.PNG (21.99 KiB) Viewed 199 times
- David Parker
- Posts: 1632
- Joined: Tue Aug 23, 2005 2:43 pm
Re: meshing error/ not responding difference
Hi Ati,
Upload your model to https://github.com/SimVascular/SimVascular/issues/398 and I'll have a look. I will also need the parameters you used for your local and regional refinements.
Cheers,
Dave
Upload your model to https://github.com/SimVascular/SimVascular/issues/398 and I'll have a look. I will also need the parameters you used for your local and regional refinements.
Cheers,
Dave