Page 1 of 1
GenBC run simulations Gateway
Posted: Mon Nov 18, 2019 10:46 am
by aloma
Hi Simvascular support team,
I was wondering if it is possible to run simulations using GenBC on the Gateway.
I've tried several times, none worked, but I couldn't figure out why.
I attached the SimVascular.stdout file returned by the Gateway.
Thanks for your help.
Aloma
Re: GenBC run simulations Gateway
Posted: Mon Nov 18, 2019 1:11 pm
by wgyang
I created a new application for genbc. Can you try it?
Thx
Re: GenBC run simulations Gateway
Posted: Mon Nov 18, 2019 1:35 pm
by aloma
Thanks for the help!
It didn't work, but I think it is because I wasn't able to upload USER.f.
The new error message:
Code: Select all
ERROR: No executable GenBC has been found
Please, make sure that you had this executable file inside runnig directory
Thanks for the efforts.
Aloma
Re: GenBC run simulations Gateway
Posted: Mon Nov 18, 2019 1:57 pm
by wgyang
Sorry about that. The input option for user.f was somehow lost when I made some changes. I added it back. Could you please try again? I tested a cylinder with GenBC. It seems to work.
Re: GenBC run simulations Gateway
Posted: Mon Nov 18, 2019 2:45 pm
by aloma
From the look of simvascular_using_genbc.stdout, now the simulation works, but Gateway doesn't create/generate any output files (no .tar file).
Re: GenBC run simulations Gateway
Posted: Mon Nov 18, 2019 6:29 pm
by wgyang
I can find my results (proc-$numprocs.czf.tar.gz) in Storage->experiment name->ARCHIVE, If the results are not generated, can you share your files so I can take a look?
Re: GenBC run simulations Gateway
Posted: Mon Nov 18, 2019 7:04 pm
by aloma
You are right, I do have the file on ARCHIVE.
I apologize for that.
Thank you so much for your help.
Aloma