Page 1 of 1
Path format
Posted: Sun Feb 02, 2020 11:11 am
by masihbln
I am trying to import the path lines obtained from simvascular into solidwork
But solidwork doesnt read .paths format
Could anyone help please?
Re: Path format
Posted: Mon Feb 03, 2020 10:33 am
by davep
Hi Masih,
A .pth file is a custom file format only used by SimVascular.
Cheers,
Dave
Re: Path format
Posted: Thu Feb 06, 2020 5:32 pm
by davep
Hi Masih,
You can create a model with constant vessel diameters in SV using the
Circle segmentation method in the
SV 2D Segmentation panel. Left click on the
Circle button to activate creating circle segmentations. You can then right-click on the
Circle button and enter a radius.
Cheers,
Dave
Hello . As I express before as a forum topic,i am trying to import the pathlibes obtained from the model or image in simvascular,into solidworks
The reason why i should creat the volume model in solidworks,is that the model must include a constant diameter for each segment of the arterial system(not int actual diameter) and i should extract only pathlines of arteries from the image.
So i need to import the pathlines into solidworks
Do you mind suggestimg me adequate procedure to do this and complete the geometry in solidwork?