simtk.org

Hi,

I was wondering if it is possible to mesh such a geometry in SV (for a solid wall)?

Thank you!

It looks like there are intersections (contact) between leaflet and outer wall. If you can get rid of them in any CAD software, you should be able to mesh the model.

Thanks Vijay, could you clarify more by get rid of the connection of the leaflets and the wall?
leaflets are connected to the aortic wall and there is a contact between them.


Thank you!

SimVascular does not allow you to model leaflet dynamics. However, you could still model flow around fixed leaflets that are, for example, fully opened to get reasonably accurate flow patterns downstream of the valve.

The image you shared seem to have leaflets penetrating into the aorta. The leaflets could still be in contact with the aorta so that it is fluid-tight but they cannot penetrate as SimVascular will then have trouble extracting faces and generating volumetric mesh. Moreover, the tips of the leaflets look very sharp and rugged. That's why I was suggesting to clean up the surface to remove any penetrations and smooth sharp corners/edges. Ultimately when you extract faces on your imported model, the entire aortic wall and the leaflets should appear as a single face in SimVascular. Otherwise, you will have issues meshing the volume.

Thanks, This is the fully open state of the valve. By fluid tight, you mean that the leaflet wall should be part of the aortic wall?
All wall faces of this imported model were combined into one wall in the modeling section but meshing did not work.

Yes, it is convenient if the leaflet is smoothly attached to the aortic wall and part of it.

If surface triangles intersect or penetrate, SV will have trouble meshing it even if you combine them to be part of the wall. If you could share the model somewhere, I will be happy to take a look at it closely.

Thank you, sure!
I remember once I shared a file with David Parker on a GitHub link that he sent.
I was wondering where I can share the model with you.