Imported STL will not Mesh
Posted: Wed Jun 26, 2024 10:50 am
Hi SimVascular Community,
My name is Melton Parham, graduate student at the University of Colorado-Boulder and I wanted to ask for any assistance with an error I am experiencing in SimVascular. The error occurs when I am trying to import a STL model created from3D Slicer into SimVascular. When attempting to complete the meshing step, the software stops at 33% and does not complete the mesh, along with this error (see attached picture)
Is there any suggestions or advice I can do to overcome this challenge?
Here is a link to the project folder if needed:
https://o365coloradoedu-my.sharepoint.c ... 1&e=vrftRB
Additionally here a few details of my setup:
OS: Windows 64
Version: SimVascular 2023.03.27(MITK 2018.4.2 VTK)
Solver: 202208-19
Thank you,
Melton
My name is Melton Parham, graduate student at the University of Colorado-Boulder and I wanted to ask for any assistance with an error I am experiencing in SimVascular. The error occurs when I am trying to import a STL model created from3D Slicer into SimVascular. When attempting to complete the meshing step, the software stops at 33% and does not complete the mesh, along with this error (see attached picture)
Is there any suggestions or advice I can do to overcome this challenge?
Here is a link to the project folder if needed:
https://o365coloradoedu-my.sharepoint.c ... 1&e=vrftRB
Additionally here a few details of my setup:
OS: Windows 64
Version: SimVascular 2023.03.27(MITK 2018.4.2 VTK)
Solver: 202208-19
Thank you,
Melton