simtk.org • Is it possible to apply flow rate and pressure as boundary conditions to a single face?

Page 1 of 1

Is it possible to apply flow rate and pressure as boundary conditions to a single face?

Posted: Mon Oct 21, 2024 1:08 am

by 0914ryo

Hello,
I am performing FSI using the svFSIplus solver.
I would like to set two boundary conditions for one surface. Is this possible?
The boundary conditions I would like to set are the time-distributed flow rate waveform and pressure waveform.

Thank you in advance.
Ryo

Re: Is it possible to apply flow rate and pressure as boundary conditions to a single face?

Posted: Mon Oct 21, 2024 10:20 am

by davep

Hi Ryo,

You can't specify both a pressure and a velocity boundary condition on the same surface since they are coupled.

Cheers,
Dave