Womersley profile
Posted: Fri Sep 15, 2017 3:13 pm
Dear SimVascular Developers,
To set the inlet boundary condition, I intend to use the Womersley profile with a variable flow rate waveform. Considering this fact, I have two questions as follows:
1) As I know, for Womersley profile the inflow waveform can be considered based on variable pressure or flow rate. However, I do not know which one has been implemented in SimVascular. If there are both of them, I do not know how I can distinguish them from each other when I want to set relevant parameters in SimVascular.
2) I am going to use a flow rate waveform based on the form of the Fourier coefficients. However, I do not know the exact formulation to compute velocity field and flow rate based on Womersley profile in your code.
Finally, I would be so grateful if you could answer the mentioned questions.
Kind Regards,
Saeid
To set the inlet boundary condition, I intend to use the Womersley profile with a variable flow rate waveform. Considering this fact, I have two questions as follows:
1) As I know, for Womersley profile the inflow waveform can be considered based on variable pressure or flow rate. However, I do not know which one has been implemented in SimVascular. If there are both of them, I do not know how I can distinguish them from each other when I want to set relevant parameters in SimVascular.
2) I am going to use a flow rate waveform based on the form of the Fourier coefficients. However, I do not know the exact formulation to compute velocity field and flow rate based on Womersley profile in your code.
Finally, I would be so grateful if you could answer the mentioned questions.
Kind Regards,
Saeid