simtk.org

Hello,

I noticed that when I look at the ground reaction force output files from inverse dynamics they do not contain moments, even though my input files do. Does this mean that AddBiomechanics is not using the moments for inverse dynamics?

Hi Duncan,

We do use GRF moments during the dynamics fitting step. Where are you not seeing them?

-Nick

Hi Nicholas,

In the ID output GRF file I am getting, the GRFs and COPs are populated but the moment columns are not. I have attached an example file.

Thanks,
Duncan

Hi Duncan,

If your original GRF files contained moments, they should get propagated to the output. Can you upload your input GRF data file?

Best,
Nick

Hi Nicholas,

The original GRF file is too large but I have attached an example portion. All the data is structured the same way.

Thanks,
Duncan

Hi Nicholas,

I was wondering if you have any insights or suggestions on what to do about this? Do you know if it is successfully using the moments in ID given the outputs? If it has to do with the format of my input file I can try different formatting.

Also, is there any way to get the calculated joint centers the AddBiomechanics uses?

Thank you,
Duncan