How to close the 'holes' of a mesh
Posted: Mon Feb 29, 2016 6:10 pm
Hello there,
is there any way in Simbody - or other software - that I can close all the holes on my mesh, so it'll be valid for simbody simulations?
It will be ok if it replaces holes with a single face (e.g. a triangle).
Thanks,
Maria K.
is there any way in Simbody - or other software - that I can close all the holes on my mesh, so it'll be valid for simbody simulations?
It will be ok if it replaces holes with a single face (e.g. a triangle).
Thanks,
Maria K.