Page 1 of 1
workflow error
Posted: Fri Jan 17, 2020 11:46 am
by kernalnet
Hi,
I faced this error in the last step of the femur mesh generation workflow.
- Capture3.JPG (126.49 KiB) Viewed 474 times
Any help would be greatly appreciated.
Cheers
Re: workflow error
Posted: Wed Jan 22, 2020 1:00 am
by brycekillen05
Hi Mohammad,
Can you send an entire screenshot of the workflow you're attempting to run. From the error it looks as if an input variable is not being passed correctly to the triangulate step, this may be either a wrong configured workflow OR at the final mesh fitting step, it was aborted instead of accepted meaning no mesh data was passed to the next step.
Thank you
Bryce
Re: workflow error
Posted: Sat Jan 25, 2020 4:10 pm
by kernalnet
Dear Bryce,
You are right.
The problem was the wrong directory of the final "geof" and "stl" output.
Sorry.
Re: workflow error
Posted: Sun Jan 26, 2020 5:38 am
by brycekillen05
Hi Mohammad,
Good to hear you figured it out.
Thanks
Bryce