simtk.org

Hello,

I downloaded the installation file (CEINMS-0.10.0-Win32), and fixed the "Warning! PATH too long installer unable to modify PATH!".
Then I attempted to check The Calibration step in the cmd window. I’ve got an error, as shown in the attached screenshot of the cmd prompt.


Will this 32-bit run on my 64-bit operating system?

Any help would be greatly appreciated.

Thanks,
Aseel

Hi Aseel,

The PATH too long message is a known problem, and you can find the solution here (viewtopicPhpbb.php?f=840&t=5883&p=0&start=0&view=).

Regarding the other error, I believe it is due to the version of OpenSim you have installed. CEINMS-0.10.0-Win32 works both on a 32 and 64 bit operating system, but only works with OpenSIm 3.3 at 32 bit, which you have to be installed correctly. I believe that error is due to the fact that you have OpenSim 3.3 at 64 bit installed in your system.

I will create and make available for download an installer for the 64 bit version of CEINMS, so it can be used with OpenSIm 3.3 64. It should solve the problem. In the meantime you can install OpenSim 3.3 at 32 bit.

Cheers
Claudio

Hi there Claudio

Are you aware of when the new version will be available?

Also, will there be an updated library on Github?

Kind regards,
Julian

I Julian,

I have the 64 bit version of CEINMS 0.10 ready to go, I just need to test it installs and works properly on a clean computer. I'll upload it sometimes next week. Sorry for the inconvenience.

Cheers
Claudio

No problem.

Thank you very much Claudio

backdrifts wrote:I Julian,

I have the 64 bit version of CEINMS 0.10 ready to go, I just need to test it installs and works properly on a clean computer. I'll upload it sometimes next week. Sorry for the inconvenience.

Cheers
Claudio

Dear Dr Claudio:
Have the 64bit of CEINMS compatible with OpenSim 3.3 been issued ? Since I got the same error when I download it just now and use it with OpenSim 3.3 on Win64.

Thanks & Best Regards,
Jack