execution error
Posted: Wed Jan 18, 2017 7:12 pm
Hi there,
I am running a simple elbow model execution. I keep getting the following error no matter what configuration I use.
Check configuration data...
Reading subject file: /../../PilotZ/ceinms/calibration/uncalibrated/PilotZ_elbow/PilotZ_uncalibrated_elbow.xml .
activeForceLength
passiveForceLength
forceVelocity
tendonForceStrain
Assuming BIClong pennation angle in radians: 0
Assuming TRImed pennation angle in radians: 0.15708
Assuming BICshort pennation angle in radians: 0
Assuming BRA pennation angle in radians: 0
Assuming BRD pennation angle in radians: 0
Assuming TRIlong pennation angle in radians: 0.20944
Assuming TRIlat pennation angle in radians: 0.15708
Assuming ANC pennation angle in radians: 0
Something is wrong. 2 muscles should be in the file and we have : 1
I have checked that my MTU and excitation names are matching. Any suggestions for what might be the problem here? Thanks in advance for your help.
Julie
I am running a simple elbow model execution. I keep getting the following error no matter what configuration I use.
Check configuration data...
Reading subject file: /../../PilotZ/ceinms/calibration/uncalibrated/PilotZ_elbow/PilotZ_uncalibrated_elbow.xml .
activeForceLength
passiveForceLength
forceVelocity
tendonForceStrain
Assuming BIClong pennation angle in radians: 0
Assuming TRImed pennation angle in radians: 0.15708
Assuming BICshort pennation angle in radians: 0
Assuming BRA pennation angle in radians: 0
Assuming BRD pennation angle in radians: 0
Assuming TRIlong pennation angle in radians: 0.20944
Assuming TRIlat pennation angle in radians: 0.15708
Assuming ANC pennation angle in radians: 0
Something is wrong. 2 muscles should be in the file and we have : 1
I have checked that my MTU and excitation names are matching. Any suggestions for what might be the problem here? Thanks in advance for your help.
Julie