Page 1 of 1

Error

Posted: Sun Jun 12, 2016 7:12 am
by tpanos
When I click the 'Run Baseline Simulation' button I get an error that the model file couldn't be found. That probably happens due to mistake regarding the file paths in the setup .xml file. Has anyone come up with a solution?

Re: Error

Posted: Fri Jun 24, 2016 11:52 am
by eschmidt01
I am having the same issue. The space in OpenSim 3.3 is throwing it off. Anyone figured this out?

BaselineModel: 'C:\OpenSim 3.3\ProbPlugin_v1_0\InverseDynamicsSetup\ProbModel_gait2392.osim'
ModelPath: 'C:\OpenSim 3.3\ProbPlugin_v1_0\InverseDynamicsSetup\'
SetupFile: 'C:\OpenSim 3.3\ProbPlugin_v1_0\InverseDynamicsSetup\OpenSimInverseDynamics_setu…'
DosCommand: 'id -S '
Tool: [1x1 org.opensim.modeling.InverseDynamicsTool]

Constructing tool from setup file C:\OpenSim.

Exception in ID: Object: ERR- Could not open file C:\OpenSim. It may not exist or you don't have permission to read it.