Hi everybody,
I'm quite new about OpenSim and I'm using it to determine the force exerted by the femoral quadriceps during a squatjump.
Do I have to execute mandatorily the CMC tool (with its high execution time) and refer to the CMC output file "*_Actuation_force.sto" or is there another faster method?
Thanks very much!
Best regards,
Cosimo Aloisi
Quadriceps force
Re: Quadriceps force
Hi Cosimo,
If you want cut down on time, you can run Static Optimization. Being an inverse method, it much runs faster than CMC.
Hope that helps,
-james
If you want cut down on time, you can run Static Optimization. Being an inverse method, it much runs faster than CMC.
Hope that helps,
-james
- Cosimo Aloisi
- Posts: 11
- Joined: Sun Feb 16, 2014 11:14 am
Re: Quadriceps force
Hi James,
however by plotting the column relative to the quadriceps force of the CMC output file "*_Actuation_force.sto" as a function of time is a correct way, isn't it?
Thanks a lot!
Best regards,
Cosimo Aloisi
however by plotting the column relative to the quadriceps force of the CMC output file "*_Actuation_force.sto" as a function of time is a correct way, isn't it?
Thanks a lot!
Best regards,
Cosimo Aloisi