Help with Probe for power

Provide easy-to-use, extensible software for modeling, simulating, controlling, and analyzing the neuromusculoskeletal system.
POST REPLY
User avatar
Frédéric Lamon
Posts: 27
Joined: Wed May 06, 2015 1:01 pm

Re: Help with Probe for power

Post by Frédéric Lamon » Thu Aug 27, 2015 8:29 am

So I modified my model a little bit in order for CMC to work with it and I ran CMC and then Probereporter in Analyze tool. I am still getting huge numbers for the actuators power (see picture) and no value for internal power of joints. Any idea ? I attached the files I used for the simulation.

Cheers,

Fred
Attachments
power_cmc.JPG
probe_cmc.zip
(6.65 MiB) Downloaded 5 times
Top
User avatar
Dario Cazzola
Posts: 44
Joined: Mon Jun 03, 2013 8:08 am

Re: Help with Probe for power

Post by Dario Cazzola » Sat Aug 29, 2015 3:40 am

Hi Fred,

Thank James, I think that was the problem!

Regarding this (which seems to be the right way to do it):
lamonf wrote:So I modified my model a little bit in order for CMC to work with it and I ran CMC and then Probereporter in Analyze tool. I am still getting huge numbers for the actuators power (see picture) and no value for internal power of joints. Any idea ? I attached the files I used for the simulation.

Cheers,

Fred
Did you use STATES as input of the Analyze Tool ?

Cheers

Dario
Top
POST REPLY