Running Analyze tool from the command line

Provide easy-to-use, extensible software for modeling, simulating, controlling, and analyzing the neuromusculoskeletal system.
POST REPLY
User avatar
Michele Vanoncini
Posts: 10
Joined: Tue Jan 27, 2009 4:32 am

Running Analyze tool from the command line

Post by Michele Vanoncini » Tue Mar 23, 2010 7:48 am

Hi,

i wonder if it is possible to run the analyze tool on the results of inverse kinematics from the command line?

I need to find the trajectory of the centre of mass during a movement...I've done this from the GUI so far.Is going through inverse dynamics the only option if I want use the command line instead?

Thanks a lot!
Top
User avatar
Ayman Habib
Posts: 2248
Joined: Fri Apr 01, 2005 12:24 pm

RE: Running Analyze tool from the command line

Post by Ayman Habib » Tue Mar 23, 2010 9:21 am

Hi Michele,

Nope. There's a separate executable "analyze" that you can invoke from the command line to run the AnalyzeTool. The setup file created from the GUI (with potentially some hand editing using an XML editor) could be used. You could add a PointKinematics analysis to find the trajectory.

Hope this helps,
-Ayman

Top
POST REPLY