Loading experimental data

[Carvell teo]

opensim data.png (204.46 KiB) Viewed 188 times

Good day, i using the mokka software to convert QTM experimental data (.c3d) to (.trc) format to support the opensim.However, after done the format converting, the skeleton show upside as the figure which are not same with my experimental data

[Ayman Habib]

Hello,

You're off by a transform to have the data match the OpenSim standard coordinate system assumptions (Y up). You can transform the data inside OpenSim to continue as described here:

https://simtk-confluence.stanford.edu/d ... ap%29+Data

Hope this helps,
-Ayman