static optimization freeze

[俊祺 蔡]

When I used OpenSim for static optimization, after clicking the "Run" button, the progress bar in the lower right corner remained stuck in the initial state, and no error was reported, and there was no error message window. The situation is shown in the attached picture.

[Chiho Ng]

Hello Junqi,

Maybe wait a moment then it would run. I have met a similar situation when I ran a RRA process, and just waited for a few minutes, I found it began to run. I think the reason of this phenomenon may be the model used to simulate is too complicate.

Hope you can find the way.

Regrads,
Chiho