Hello everyone!
When I finish solve the study and obtain a MocoSolution, I want to extract the information I want from the Moco simulation results.
In the matlab moco simulation, I use the following code to extract the target result information.
gaitTrackingSolution = study.solve();
outputs = StdVectorString();
outputs.add('/jointset/groundPelvis/pelvis_tilt/value');
table = study.analyze(gaitTrackingSolution,outputs);
However, the desired results cannot be obtained, and the following warning prompts are provided:
"Warning: No outputs were connected to 'reporter' of type TableReporter__double_. You can connect outputs by calling addToReport()."
I hope someone can help me and look forward to any response from you.
Thank you very much!
Song Jingke
How to compute outputs from the solution in Moco
- Jingke Song
- Posts: 34
- Joined: Tue Oct 19, 2021 4:52 am
- Jingke Song
- Posts: 34
- Joined: Tue Oct 19, 2021 4:52 am
Re: How to compute outputs from the solution in Moco
OK, I have found the cause of the problem.