The simulation conditions are as follows
The model "arm26" was used.
The simulation was performed for 20 seconds.
The excitation was entered only for "BIClong" and its value was increased proportionally from 0 to 0.12 from the beginning of the simulation (0 sec) to the end time (20 sec).
The model was set up so that no excitation was given to the muscles other than "BIClong" and their values were always constant at 0.
The initial state of the model was set to the value obtained when the simulation was performed without any input to the model (i.e., all muscle excitation was set to 0) and the model was in a state of complete weakness. Specifically, the elbow joint angle was set to approximately 23.2 degrees.
As a result of this simulation, the value of the "BIClong" activation, to which the input was given, decreased to a negative value immediately after the start and increased according to the input after a few seconds.
For the muscles other than BIClong, which were not given any input, the activation values decreased to negative values from the start of the simulation until the end of the simulation.
Shouldn't the value of activation take a value between 0 and 1 and not go negative?
I have attached the xml file for the control of the excitation input I used and the resulting file.