Hello
I am new to Opensim and not much of a coder..... I am trying to use the scale tool for a trial where I use the plug in gait model for the lower limbs however I have problems with the measurement set file not sure if the file I am using is completely correct but I believe I have modified it to work with a plug in gait model but I can not even load it I have the following error failed to open file "......." (line=0, col=0) required condition LoadOK was not met any tips on this error I have been exploring the measurement set file of the opensim examples but I am at a loss at the moment. Any help would be greatly appreciated.
Kind regards
Silly beginner question
-
Ayman Habib
- Posts: 2248
- Joined: Fri Apr 01, 2005 12:24 pm
Re: Silly beginner question
Hi,
It's hard to tell what your setup/files are like but this sounds like a file you're trying to access that may not exist or have incorrect format. If you can send the full message/context or screen capture it would be great. Please note that because of a bug (https://simtk.org/tracker/index.php?fun ... 1&atid=322) you can't run the scale tool more than once while the tool is open. A workaround is to close the tool and relaunch it. If you have your settings saved to a file that shouldn't be a big problem.
Best of luck and please let us know if you continue to have problems,
-Ayman
It's hard to tell what your setup/files are like but this sounds like a file you're trying to access that may not exist or have incorrect format. If you can send the full message/context or screen capture it would be great. Please note that because of a bug (https://simtk.org/tracker/index.php?fun ... 1&atid=322) you can't run the scale tool more than once while the tool is open. A workaround is to close the tool and relaunch it. If you have your settings saved to a file that shouldn't be a big problem.
Best of luck and please let us know if you continue to have problems,
-Ayman