Dear All,
My name is Yuma IESHIRO. I study in Japanese Doshisha University.
I try that I build OpenSim3.0 from a source. Thanks to Simbody Project Site, Simbody3.0 was able to build. However, I cannot build OpenSim3.0.
To see the Support Portal for OpenSim 3.0, I made the sln file. However, an error is given without being able to read every header file when I am going to build ALL_BUILD. Can you not set the pass?
I use it:
Visual C++ express 2010
Windows 7 (x64)
I would appreciate any advice from anyone.
Regards,
yuma
Building OpenSim from Source
- Ayman Habib
- Posts: 2244
- Joined: Fri Apr 01, 2005 12:24 pm
Re: Building OpenSim from Source
Hi,
Likely you have a problem with pointing OpenSim to your Simbody installation. Can you explain where things went wrong (what step?)
Best regards,
-Ayman
Likely you have a problem with pointing OpenSim to your Simbody installation. Can you explain where things went wrong (what step?)
Best regards,
-Ayman
- yuma ieshiro
- Posts: 7
- Joined: Thu May 12, 2011 11:26 pm
Re: Building OpenSim from Source
Dear Ayman.
Thanks for letting me know.
When ALL_BUID is built, the following errors come out of this problem.
・The error of C1083 comes out.
・In particular, SimTKcommon.h cannot be read.
・Probably, the header file included in Simbody and SimTKmath,SimTKcommon cannot be read.
All the processes in which a sln file is made are performed as the support site.
Best regards,
yuma
Thanks for letting me know.
When ALL_BUID is built, the following errors come out of this problem.
・The error of C1083 comes out.
・In particular, SimTKcommon.h cannot be read.
・Probably, the header file included in Simbody and SimTKmath,SimTKcommon cannot be read.
All the processes in which a sln file is made are performed as the support site.
Best regards,
yuma
- Ayman Habib
- Posts: 2244
- Joined: Fri Apr 01, 2005 12:24 pm
Re: Building OpenSim from Source
Hi Yuma,
Again I think you need to make sure the CMake variable SimTK_INSTALL_DIR is set correctly, this would be the directory you selected to install Simbody after it's done building. The files should be copied to this directory by executing the INSTALL target at the end of the Simbody build.
Hope this helps and please let me know if you continue to have problems.
-Ayman
Again I think you need to make sure the CMake variable SimTK_INSTALL_DIR is set correctly, this would be the directory you selected to install Simbody after it's done building. The files should be copied to this directory by executing the INSTALL target at the end of the Simbody build.
Hope this helps and please let me know if you continue to have problems.
-Ayman