Page 1 of 1

bushingforce

Posted: Tue Mar 12, 2019 3:33 am
by cjszero
I would like to ask a simple question. I defined a bushingforce between the exoskeleton and the model, and then successfully performed ik, id, cmc on the model. But where can I plot the bushingforce I defined? I can only find muscle strength, thank you for your reply.

Re: bushingforce

Posted: Tue Mar 12, 2019 7:08 am
by mitkof6
You might add a ForceReporter through the Analyze Tool which reports all forces that act on the model.

https://simtk-confluence.stanford.edu/d ... lysis+Tool