simtk.org • Static Optimization

Page 1 of 1

Static Optimization

Posted: Fri Apr 30, 2021 1:56 am

by annabichi

Hi every one,
I have an upper body model, and I'm trying to do Static Optimization on Opensim Gui.
When I load the .mot file, the actuators file and I launch the tool this error message appear:
Assembly error tolerance achieved: 1.5203293311782939e-10 required: 1e-10.
Model relaxing constraints and trying again.
Anyone knows I can I handle that?
Thank you very much in advance

Re: Static Optimization

Posted: Sat Jun 05, 2021 3:10 am

by water-19

annabichi wrote: ↑
Fri Apr 30, 2021 1:56 am
Hi every one,
I have an upper body model, and I'm trying to do Static Optimization on Opensim Gui.
When I load the .mot file, the actuators file and I launch the tool this error message appear:
Assembly error tolerance achieved: 1.5203293311782939e-10 required: 1e-10.
Model relaxing constraints and trying again.
Anyone knows I can I handle that?
Thank you very much in advance

Hello,OpenSim sets the initial error to 1E-10. Your current model has a larger error than that, so OpenSim automatically adjusts the error and allows the program to execute.If you don't end up with a big error, I think it is OK.Let it alone