Page 1 of 1
Error using c3dExport.m
Posted: Wed May 18, 2022 10:40 am
by jobingthampi
Iam getting error when I run this section
Re: Error using c3dExport.m
Posted: Thu May 19, 2022 3:09 am
by tkuchida
Are you sure c3dExport.m supports OpenSim 4.3? Perhaps try using the C3DFileAdapter instead (see the "C3D (.c3d) Files" page in the Documentation here:
https://simtk-confluence.stanford.edu:8 ... d%29+Files).
Re: Error using c3dExport.m
Posted: Fri May 20, 2022 6:53 pm
by jobingthampi
Hi sir, that was my mistake before but now i tried using ezc3d(), and this is the error it's showing now
Re: Error using c3dExport.m
Posted: Fri May 20, 2022 7:06 pm
by jobingthampi
Also if iam using ezc3dRead() how can i get .trc and .mot files to perfom IK(inverse kinematics) and ID(inverse dynamics)