CMC Fails
Posted: Thu Mar 30, 2023 3:48 pm
Hi Dear,
I have been using the lower limb model to analyze human gait
I encountered a problem when I used the CMC fails after running the simulation.
Note: that the gait is sitting position 90 degrees the right leg the pelvis still remains on the same place, the segment of the knee will move a little bit against load.
Is there a simple solution to this problem? Any help is appreciated
with the best regards,
I have been using the lower limb model to analyze human gait
I encountered a problem when I used the CMC fails after running the simulation.
Note: that the gait is sitting position 90 degrees the right leg the pelvis still remains on the same place, the segment of the knee will move a little bit against load.
Is there a simple solution to this problem? Any help is appreciated
with the best regards,