Page 1 of 1
help with RRA
Posted: Thu Oct 29, 2009 1:21 pm
by bunker
I've go trought scaling and inverse kinematics of a gait analisys test. During RRA the process, after about 1 second on wich i see the model "walking" like in IK the process became very slow and the model start to "fall" moving in the -Y direction....
I've used Gait2392 model adapted for a Davis protocol. I made changes to RRA_Actuator.xml file to reflect pelvis mass center after scaling but nothing change.
Some one can help me ?
Thank you
Andrea
RE: help with RRA
Posted: Mon Nov 02, 2009 4:34 pm
by aymanh
Hi Andrea,
As a first step, can you check the Wiki page below:
http://wiki.simtk.org/opensim/rraCmcPage
I'd particularly check that GRF are applied ( to the correct segment). I'd also check that
residuals at pelvis are applied correctly.
-Ayman
Re: help with RRA
Posted: Thu Mar 14, 2013 4:54 pm
by gauravm
Did you find a solution to your problem Andrea? Could you please update the conversation? I'm facing the same issue albeit with a lift task. Thanks!
Re: help with RRA
Posted: Sun Mar 17, 2013 11:37 am
by pmd92
Hi Andrea,
I had this problem with a model I am working on and found it was due to the application of the GRF data. I only have GRF's for a portion of the motion data (two force plates in the middle of the lab) so I run RRA for a time interval that I have the GRF's for. Specifically, I run RRA from when the right foot is on the right force-plate and left foot has left the ground, until the left foot is on the left force-plate and the right foot has left the right force-plate.