Page 1 of 1
OpenSim Scale Issue
Posted: Mon Jan 29, 2024 1:52 am
by suvitti
- Screenshot (63).png (253.59 KiB) Viewed 806 times
I need to scale my data on a Full Body Model. I found this Adjusted ULB Model which works on OpenSim 3.3 version.
When I try to scale the model on my laptop (Windows 64 bit), the scaling doesn't happen well (screenshot attached).
- Screenshot (64).png (391.44 KiB) Viewed 806 times
- Screenshot (65).png (447 KiB) Viewed 806 times
But when I scale the same data on the same model on a Desktop (Windows 64-bit), the scaling seem to be fine but the model appears distorted once the RRA is done. I'm unable to figure out what the problem must be.
Re: OpenSim Scale Issue
Posted: Mon Jan 29, 2024 2:36 pm
by aymanh
Hello,
My recollection is that this was an issue with visualization rather than scaling due to the fact that the model uses custom geometry/mesh files that the scaled model can't find. If you save the scaled model in the same folder as the original/pre-scale model and reopen it, it will display correctly. I remember this issue was fixed in the 4.0 code base so the problem should be fixed in the latest 4.4+ distributions. Please let us know otherwise.
Best regards,
-Ayman
Re: OpenSim Scale Issue
Posted: Thu Feb 08, 2024 3:29 am
by suvitti
Hi Ayman,
Thankyou so much. The suggestion worked like a magic.
Regards
Suvitti