Hi,
During the development of a 14 segment model I wanted to check the progress made using FD.
However I cannot complete simulation due to an unexpected exception, freezing or crashing of OpenSim 3.1.
I have attached the model and would like to know if anyone can spot an irregularity that should be fixed.
Mind you, only joints, mass, segment lengths and coordinate limiting forces are implemented at this stage.
Best regards
Unexpected exception, freeze or crash during FD
-
Koen Peters
- Posts: 7
- Joined: Thu Sep 26, 2013 2:10 am
Unexpected exception, freeze or crash during FD
- Attachments
-
- 14Segment.xml
- (121.05 KiB) Downloaded 90 times
-
Koen Peters
- Posts: 7
- Joined: Thu Sep 26, 2013 2:10 am
Re: Unexpected exception, freeze or crash during FD
My appologies for replying to my own post.
I haven't solved the problem yet, however I did manage to isolate the problem.
When the shoulder coordinate limiting forces are left out, the model simulates as expected.
However, I was unable to detect an actual flaw in my shoulder coordinate limiting forces, could anyone else shed some light on this issue?
Best regards,
Koen
I haven't solved the problem yet, however I did manage to isolate the problem.
When the shoulder coordinate limiting forces are left out, the model simulates as expected.
However, I was unable to detect an actual flaw in my shoulder coordinate limiting forces, could anyone else shed some light on this issue?
Best regards,
Koen