Page 1 of 1
Can't save model
Posted: Tue Jan 07, 2014 12:17 pm
by aj4
I'm just getting started with OpenSim and working my way through Tutorial1. I've manipulated the model, flexed the hip to 45 degrees, saved the Pose, saved the Model. Then I close the model, and open it again, and the new 45 degree hip flex pose is gone.
How do I save the model?
Thanks,
AJ
Re: Can't save model
Posted: Tue Jan 07, 2014 5:30 pm
by jimmy
Hi Aj,
Once you change the coordinates, go to 'poses>>Set Default'.
Then Save the model.
Cheers,
-james
Re: Can't save model
Posted: Wed Jan 08, 2014 5:43 pm
by jp123909
hi,
you should set your coordinate value to default one.
plz see the attachment
Re: Can't save model
Posted: Thu Jan 09, 2014 12:53 pm
by aj4
Hi Thanks!
So, I can only save one pose - the "Default" pose? I tried creating a few different poses, saved them as "new" poses, then saved the model and quit. When I opened the model again, only the Default pose was still there.
Re: Can't save model
Posted: Thu Jan 09, 2014 7:37 pm
by eskilan
That is correct. Each model can only have one default pose.