simtk.org

Hi! I'm just getting started with CMC. I have all of the necessary files made (I think!), but when I try to run CMC I keep getting an error that says, "Exception in analyze: AnalyzeTool.initializeFromFiles. Either a states file or a coordinates file must be specified." Does that mean something is wrong with my motion file or something? I did not make an actuator constraints file (is that necessary?), but I do have a kinematics file, a tracking tasks file, time range, actuators, and external loads all included...

Thanks!

Ashley

Hi Ashley,

It looks like the setup files are invoking the analyse tool, which is probably not what you want? Check your CMC setup file against the CMC setup file in the gait2392 folder to see if this is the case.

Cheers,
-james