simtk.org

Hello,

I am new to Opensim, and I am trying to use the Upper Extremity Dynamic Model while it is not loading in Opensim 3.2. when I load this in Opensim 3.2 ,it shows:

"MovingPathPoint:: Components of the same path point must depend on same the coordinate. Condition: x_coordinate == y_coordinate == z_coordinate FAILED."

so,do have any adjust to make the model fit for 3.2 ?

Any suggestions will be greatly appreciated.

Hello Wang,

Maybe it will help, check if you have the folder Geometry along with the .osim file when you load it.

Best regards,
Jim

Hello Wang,

In the instructions for the download there is a comment that says; "Note that we recommend use of OpenSim 3.1, 64 bit. Release 3.2 currently conflicts with the model."

I hope this helps.
Anthony