simtk.org

Recently I have been having some problems with the CMC tool and I would like to ask for your help. In this topic I attached a screen shot with the set up that I use (2) and another with the error message (that sometimes appears in the beginning of the process and other times just appears in the middle, when the percentual counting is already activated). Hope that you can help me. Thank you so much.
Best regards,
Ana Lúcia Castro

Propably muscles are to weak, you have tried to increase the constraints value for residual actuators in constraint .xml file?

Please check the degree of freedom. You may lock some degree of freedom which are necessary for the simulation.

Thanks
Hassan