simtk.org

Hi there,

When I try to preview the external load data, there's nothing shown in the screen but the axis. I have checked the data file, the headings are fine. What can be the cause of this problem?

Any advice would be helpful. Thank you!

Perhaps try previewing Models/Gait2354_Simbody/subject01_walk1_grf.mot. If that works, you can compare with your file to hopefully identify the issue.

tkuchida wrote:Perhaps try previewing Models/Gait2354_Simbody/subject01_walk1_grf.mot. If that works, you can compare with your file to hopefully identify the issue.

Thanks for your reply.
I have tried the example file, and it did work. I have also compared the components of these two files. The only thing different is the pattern of ground reaction moments. May I ask where is the reference point for ground reation moments? And what else causes would lead this problem?

I have also compared the components of these two files. The only thing different is the pattern of ground reaction moments.

It isn't clear how this would be possible if the only differences are the values in the columns corresponding to moments. There are several possible explanations (incorrect header, missing values, tiny forces, etc.). Rather than attempt to list every possibility, it would probably be easier if you could upload your file and I'll take a look.

tkuchida wrote:

I have also compared the components of these two files. The only thing different is the pattern of ground reaction moments.

It isn't clear how this would be possible if the only differences are the values in the columns corresponding to moments. There are several possible explanations (incorrect header, missing values, tiny forces, etc.). Rather than attempt to list every possibility, it would probably be easier if you could upload your file and I'll take a look.

My file is attached. Thank you for your help.

The points of application must be specified in meters. The magnitudes of the values in your "ground_force_px", "ground_force_py", "ground_force_pz", "1_ground_force_px", "1_ground_force_py", and "1_ground_force_pz" columns are too large to be visible in the View window without a lot of zooming/panning. The arrows can be seen when all values in these six columns are divided by 1000 (I'm assuming they were specified in mm).

tkuchida wrote:The points of application must be specified in meters. The magnitudes of the values in your "ground_force_px", "ground_force_py", "ground_force_pz", "1_ground_force_px", "1_ground_force_py", and "1_ground_force_pz" columns are too large to be visible in the View window without a lot of zooming/panning. The arrows can be seen when all values in these six columns are divided by 1000 (I'm assuming they were specified in mm).

It is solved. Thanks a lot!