Step angles in motion file

Provide easy-to-use, extensible software for modeling, simulating, controlling, and analyzing the neuromusculoskeletal system.
POST REPLY
User avatar
Krishnakumar Sankar
Posts: 115
Joined: Tue Mar 01, 2016 10:06 am

Step angles in motion file

Post by Krishnakumar Sankar » Thu Mar 30, 2017 3:23 am

I created the below .mot file to determine the joint moments and muscle moments of the fingers.
But static optimization doesn't run for this motion file (which is not my requirement as I need only joint and muscle moments).Because SO doesnt run,is this way of creating a motion file wrong? .
Example.mot
(1.61 KiB) Downloaded 89 times
Top
User avatar
Dimitar Stanev
Posts: 1096
Joined: Fri Jan 31, 2014 5:14 am

Re: Step angles in motion file

Post by Dimitar Stanev » Thu Mar 30, 2017 11:53 pm

Hi,

What is the message when you run SO?
Top
User avatar
Krishnakumar Sankar
Posts: 115
Joined: Tue Mar 01, 2016 10:06 am

Re: Step angles in motion file

Post by Krishnakumar Sankar » Fri Mar 31, 2017 3:10 am

Its stuck.Not at all running.Will it matter for determining only joint moments and muscle moments or atleast for joint moments
Top
User avatar
Thomas Uchida
Posts: 1793
Joined: Wed May 16, 2012 11:40 am

Re: Step angles in motion file

Post by Thomas Uchida » Fri Mar 31, 2017 8:26 pm

What model are you using? Have you confirmed that all relevant bodies have nonzero mass?
Top
User avatar
Bart van Veen
Posts: 9
Joined: Tue Jun 23, 2015 5:40 am

Re: Step angles in motion file

Post by Bart van Veen » Sun Apr 02, 2017 7:35 pm

If I open your .mot in Excel, the column headers and data columns are not aligned and the whole looks really messy. You might want to check your delimitation.
Top
User avatar
Krishnakumar Sankar
Posts: 115
Joined: Tue Mar 01, 2016 10:06 am

Re: Step angles in motion file

Post by Krishnakumar Sankar » Sun Apr 02, 2017 8:57 pm

@Tom Uchida
Thanks a lot sir
I am using Wrist model.I now made sure that All the relevant body masses are non zero.It got executed :-) .
Top
POST REPLY