Page 1 of 1
Step angles in motion file
Posted: Thu Mar 30, 2017 3:23 am
by kishan
I created the below .mot file to determine the joint moments and muscle moments of the fingers.
But static optimization doesn't run for this motion file (which is not my requirement as I need only joint and muscle moments).Because SO doesnt run,is this way of creating a motion file wrong? .
Re: Step angles in motion file
Posted: Thu Mar 30, 2017 11:53 pm
by mitkof6
Hi,
What is the message when you run SO?
Re: Step angles in motion file
Posted: Fri Mar 31, 2017 3:10 am
by kishan
Its stuck.Not at all running.Will it matter for determining only joint moments and muscle moments or atleast for joint moments
Re: Step angles in motion file
Posted: Fri Mar 31, 2017 8:26 pm
by tkuchida
What model are you using? Have you confirmed that all relevant bodies have nonzero mass?
Re: Step angles in motion file
Posted: Sun Apr 02, 2017 7:35 pm
by bartvanveen
If I open your .mot in Excel, the column headers and data columns are not aligned and the whole looks really messy. You might want to check your delimitation.
Re: Step angles in motion file
Posted: Sun Apr 02, 2017 8:57 pm
by kishan
@Tom Uchida
Thanks a lot sir
I am using Wrist model.I now made sure that All the relevant body masses are non zero.It got executed
.