simtk.org • Ground alignment between mocap and simulation

Page 1 of 1

Ground alignment between mocap and simulation

Posted: Fri May 12, 2017 1:45 pm

by gmast

Hi,

I have loaded a FullbodyModel using mocap data, but it seems that there is a misalignment between the mocap ground height and the OpenSim ground height as seen in the attached image.

: photo1.png (19.09 KiB) Viewed 188 times

Any reason why this is happening?

Thanks

Re: Ground alignment between mocap and simulation

Posted: Fri May 12, 2017 3:53 pm

by jimmy

There is most likely an offset being applied to the model. Right-click on the model in the navigator and select model offset.

Re: Ground alignment between mocap and simulation

Posted: Mon May 15, 2017 3:36 am

by gmast

Excellent! Thank you!