Static Optimization Workflow for Joint Reaction
Posted: Thu Aug 24, 2017 10:22 am
Hi there,
I had a query about the file "subject01_walk1_Kinematics.sto" used in the webinar for estimating joint loads in OpenSim, http://opensim.stanford.edu/support/eve ... in-OpenSim
I completed the webinar with no issues but as the example overlooks the steps from static optimization back I thought it would be good practice to take the Gait2392_Simbody model and perform the full analysis from the start, hoping to get the same/similar results.
Scaling the model was fine, performing inverse kinematics using "subject01_walk1.trc" was fine.
However, at this point I was not sure whether to perform Static Optimization with filtered IK results, to perform RRA the SO, forwards dynamics and SO, or other workflow variations etc.
I know in the webinar that this file "subject01_walk1_Kinematics.sto" is used for the Joint Reaction Analysis however I would like to know what workflow was performed to get this file? Is it an externally filtered IK.mot file?
I cannot seem to produce the same results using any of the different workflow variations I have tested compared with the results when using "subject01_walk1_Kinematics.sto".
If anyone has any insight on this that would be great.
Thanks,
Karen
I had a query about the file "subject01_walk1_Kinematics.sto" used in the webinar for estimating joint loads in OpenSim, http://opensim.stanford.edu/support/eve ... in-OpenSim
I completed the webinar with no issues but as the example overlooks the steps from static optimization back I thought it would be good practice to take the Gait2392_Simbody model and perform the full analysis from the start, hoping to get the same/similar results.
Scaling the model was fine, performing inverse kinematics using "subject01_walk1.trc" was fine.
However, at this point I was not sure whether to perform Static Optimization with filtered IK results, to perform RRA the SO, forwards dynamics and SO, or other workflow variations etc.
I know in the webinar that this file "subject01_walk1_Kinematics.sto" is used for the Joint Reaction Analysis however I would like to know what workflow was performed to get this file? Is it an externally filtered IK.mot file?
I cannot seem to produce the same results using any of the different workflow variations I have tested compared with the results when using "subject01_walk1_Kinematics.sto".
If anyone has any insight on this that would be great.
Thanks,
Karen