External Loads Specification

[Arash Mohammadzadeh Gonabadi]

Hello everybody,

I have a question. I was wondering to create the external force (Force,COP,Torque), when we fill the form based on the following items at the same time:

- applies force --> point force --> (force columns and point columns)
- applies torque --> torque columns

1. Does Opensim ignore "torque columns" and just use "force columns" and "point columns"? or it use torque, force, and points at the same time?

2. If we have data from Force, Torque, and COP, can we just use force and COP?

Thank you so much.