Page 1 of 1
Scale Tool
Posted: Wed Sep 19, 2018 2:29 am
by opensim_zp
Hello, everyone,
I'm new in OpenSim. Rcently, I encountered a problem when I used the Scale Tool in OpenSim. I imported the data of motion capture collected into OpenSim, but the RMS in my results of scaling was always quite big. And I cannot find the experiment markers in the View Interface, where are only the virtual markers I set. Can anyone help me?
Re: Scale Tool
Posted: Wed Sep 19, 2018 5:40 am
by hhj
hi,
I also encountered a similar problem during the zooming process. I want to know what is the unit of RMS displayed in the message window?After running the opensim scaling example, the message window produces the result RMS=0.0332069. What is its unit?
Re: Scale Tool
Posted: Wed Sep 19, 2018 6:18 pm
by opensim_zp
hhj wrote: ↑Wed Sep 19, 2018 5:40 am
hi,
I also encountered a similar problem during the zooming process. I want to know what is the unit of RMS displayed in the message window?After running the opensim scaling example, the message window produces the result RMS=0.0332069. What is its unit?
The unit is meter.
Re: Scale Tool
Posted: Thu Sep 20, 2018 2:43 am
by hhj
opensim_zp wrote: ↑Wed Sep 19, 2018 6:18 pm
hhj wrote: ↑Wed Sep 19, 2018 5:40 am
hi,
I also encountered a similar problem during the zooming process. I want to know what is the unit of RMS displayed in the message window?After running the opensim scaling example, the message window produces the result RMS=0.0332069. What is its unit?
The unit is meter.
Isn't that the scaling of the sample program not good?