laboratory coordinate system
Posted: Wed Aug 10, 2016 3:02 pm
Hi,
As shown in the figure below, which demonstrates the laboratory and FP coordinate system. Should I define the laboratory coordinate system as: (YZX), then I have to set the motion direction as “backward”? Also for the selection of 90left OR 90right is that according to the direction of motion? Another question, here the laboratory coordinate system is (YZX), while the OpenSim coordinates (XYZ), so I have to rotate the laboratory coordinates to OpenSim. Alice Mantoan mentioned that Rotations to OpenSim are automatically computed, could you please clarify this point in details.
Thanks in advance,
Aseel.
As shown in the figure below, which demonstrates the laboratory and FP coordinate system. Should I define the laboratory coordinate system as: (YZX), then I have to set the motion direction as “backward”? Also for the selection of 90left OR 90right is that according to the direction of motion? Another question, here the laboratory coordinate system is (YZX), while the OpenSim coordinates (XYZ), so I have to rotate the laboratory coordinates to OpenSim. Alice Mantoan mentioned that Rotations to OpenSim are automatically computed, could you please clarify this point in details.
Thanks in advance,
Aseel.